Zvizzer FC 2000 | Fine Cut Compound & Hologram Remover

Zvizzer FC 2000 - A Flawless, Hologram-Free Finish

FC 2000 is Zvizzer's fine cut hologram remover, the finishing stage that takes your correction from just good - to flawless.

It clears the holograms, buffer trails and micro-haze defects that heavier compounds leave behind, refining the paint to a 100% hologram-free, mirror-uniform finish. This is the polish that makes evidence of the harder work disappear before your eyes.

An intelligent, self-diminishing aluminium oxide abrasive is the key: it refines continuously as you polish, breaking down to an ever-finer cut so it lifts defects without leaving any of its own. The entirely water-based, silicone-free formula stays low on dust and wipes off cleanly. Use it after heavier cutting stages, or on its own to remove buffer trails, on all paint systems including scratch-resistant clear coats, fresh or fully cured.

No holograms, no haze, just a flawless finish.

Application

FC 2000 works with both rotary and orbital machines, and a dual action orbital makes the finishing stage faster still. Start with a clean pad and prime it before your first pass. Apply a small amount of compound to the pad or the panel and spread to cover your working area.

On a rotary, spread at around 650 rpm, then finish at roughly 1,200 rpm under light to moderate pressure. On an orbital, spread on speed 1 and work up to speed 5. Either way, work one section at a time.

Keep two or three pads on the go and swap them between sections. Letting each pad cool holds the finish consistent and hologram-free. Available in 250ml and 750ml.

Works well with

• Yellow Thermo Allrounder Pad - the colour-matched finishing pad for FC 2000
• Zvizzer Clean Top - panel wipe to neutralise the paint before you protect it
• Graphene Ceramic Coating - lock in the flawless finish with long-term protection
• Zvizzer Microfibre Cloths - colour-coded, lint-free cloths for a clean wipe-off and no cross contamination